How To Jump A C Compressor Clutch. About all I havent done is had the refrigerant evacd and weighed to make sure theres plenty in there. You can jump the low pressure sensor wiring harness by your receiver dryer and see if the clutch grabs and turns the compressor.
Using a 12-volt test light connect the alligator clip to the negative terminal on the battery. You do this by turning the AC on with the relay removed put your red lead of your meter on battery positive and the black ground lead on pin 85. You can jump the low pressure sensor wiring harness by your receiver dryer and see if the clutch grabs and turns the compressor.
You do this by turning the AC on with the relay removed put your red lead of your meter on battery positive and the black ground lead on pin 85.
If your AC is an older model jumps-start can be a good option. My question is why wouldnt they be able to. I done pretty much All of it replaced ac compressor reciever drier both Binery switches on the receiver fan blower motor Evaporator temp sensorcdtc duct flow sensor Fuse panel relay fuses flushed the system before Before closing it. Hook one end of the fused jumper wire to the compressor side of the wire connector.
